Manufacturer: ELM Video Technology
MPN/Model: DSR4-WM
Name: DMX 1x4 Splitter w RDM Pass Through
UL Listings: 5V power supply & PCB pre populated
FUSE: 500mA SMT
POWER: Apx 450mA with 4 outputs sourcing 32 loads each
DATA TYPE: DMX512 (250Khz)
DATA INPUT: DMX512 - Pin 1 - (Shield) Not connected, Pin 2 Data - , Pin 3 Data +,
DATA OUTPUT: 4 separate DMX512 outputs - Pin 1 - Power supply common, Pin 2 Data -, Pin 3 Data +
RDM: Pass Through
Dimensions: 3" x 6.2" x 1.3" (inches)
Weight: 8 oz
External Power Supply: +5VDC wall mount
Voltage Input: 100 ~ 132 (or 240) VAC
Current Output: 1A
Power: 5 Watts Typical
Polarization: Positive Center
Output Connector: Barrel Plug, 2.5mm I.D. x 5.5mm O.D. x 9.5mm

Optional IC Sockets for driver chips
Optional chip set upgrade (recommended if the DMX wiring is near power lines, used outdoors, and/or near water)

The DSR4-WM is a DMX 1 in 4 out splitter with RDM pass through. Front indicators show the unit power and data status including RDM. The DSR4-WM DMX Splitter (distributor, buffer, amplifier, booster) actively splits the DMX signal providing 4 separate DMX outputs. The outputs are electronically isolated from each other and each output can source up to 32 devices (DMX512 standard). Includes 5V power supply.

For improved output isolation select the chipset upgrade for TVS "Transient Voltage Suppression" chips installed (recommended if the DMX wiring is near power lines, used outdoors, and/or near water).